Apple iPad (POP3)
To configure iPad to receive and send email using our servers over POP3 and SMTP, you can follow the steps below. In this manual we are using example domain name and email address, so please make sure to replace:
1. On your iPad's home screen, tap Settings. 2. Tap Mail, Contacts, Calendars, then tap Add Account.
3. Tap Other, then tap Add Mail Account.
4. In the Name field you should enter the name that would appear on the messages you send. Tap the Next button.
5. Tap POP. For Host Name in the Incoming Mail Server section use mail.domain-name-example.com (replace domain-name-example.com with your domain name). For Host Name in the Outgoing Mail Server section use mail.domain-name-example.com (replace domain-name-example.com with your domain name). Tap the Save button at the top of the screen.
6. Mail will verify your settings by connecting to the server. You will need to have an active Internet connection for that.
7. Tap your account under Accounts.
8. Scroll to the Outgoing Mail Server section.
9. Tap on the SMTP setting.
10. Under Primary Server tap mail.domain-name-example.com.
11. Make sure that Use SSL is set to OFF and that Server Port is set to 587. Tap on the Done button. Tap on the back arrow button at the top of the page.
12. Tap Advanced.
13. Make sure that Use SSL is set to OFF, and that the Server Port is 110, then go back to the previous page. Tap the Done button at the top right corner of the screen. You can add additional email accounts by repeating the same procedure. |